| Runtime | ANSI/PLATO FL 1 runtime is the time a light operates before its output falls to 10% of the measured initial output under the specified test conditions. | Compare runtime figures only when the tested mode, battery configuration, and test basis are alike. A high-output mode will generally run for less time than a low-output mode. | Choose a light with a published runtime for the mode you expect to use. Treat runtime as a standardized comparison, not a guarantee of identical results in every jobsite condition. |
| Impact Resistance | FL 1 impact resistance is reported as a drop height in meters. It indicates the height from which a tested light can withstand drops under the standard’s test procedure. | Compare the stated height and confirm that the product listing identifies it as an FL 1 impact-resistance result. Do not assume a higher rating means the light is resistant to every type of impact. | For frequent handling or work around hard floors, prioritize a published impact rating and a housing designed to protect the light’s moving and electrical parts. |
| Water Resistance | FL 1 water-resistance information describes performance under defined water-exposure testing. It does not, by itself, establish resistance to dust, chemicals, or all forms of moisture. | Check the exact water-resistance marking and its test conditions. If a separate IP code is listed, read that code independently rather than treating it as interchangeable with an FL 1 result. | Match the stated protection to the work environment. For outdoor or wet-area use, look for clearly documented water protection and follow the manufacturer’s limits for charging and storage. |
| Flexible Positioning | Hinges, pivots, magnetic bases, hooks, and clamps are useful design features, but they are not FL 1 performance ratings. | Check the advertised adjustment range and whether the light can remain stable in the positions needed for your task. Consider the surfaces and mounting points available at the jobsite. | Choose a base or attachment system that suits your work area. A flexible head is most useful when it can be aimed without the light tipping or needing to be held. |
| Battery and Charging | Battery capacity, recharge time, replaceability, and charging method are product specifications, not substitutes for a standardized runtime test. | Compare runtime together with battery details and charging information. Check whether the stated runtime applies to a particular brightness setting or battery pack. | For long shifts, consider whether the battery can be replaced or recharged during breaks, and whether the light can operate while charging if that feature is important. |
| Brightness and Beam | Light output and beam characteristics describe how much light is produced and how it is distributed. They do not alone indicate runtime or durability. | Compare output figures on equivalent modes and consider whether the beam is broad enough for close work. A higher output setting may reduce operating time. | For workbench and repair tasks, prioritize useful, even illumination and a controllable output mode rather than selecting by maximum brightness alone. |
| Test Conditions and Documentation | FL 1 figures are standardized test results; actual performance can vary with temperature, battery condition, settings, and use. | Look for the rating, test standard, mode, and relevant conditions in the product documentation. Avoid comparing a tested figure with an undefined marketing estimate. | Use published test information to narrow choices, then confirm that the light’s battery, mounting, and protection features fit the conditions in which it will be used. |