| Rolling bearings | Bore and outside diameter, load ratings, speed limit, clearance, lubrication, sealing, and operating temperature. | Request dimensional and material documentation, traceability details, and confirmation that the bearing suits the shaft, housing, load, and environment. | Compare purchase price with lubrication needs, replacement labor, downtime risk, and expected service life under the actual load and operating conditions. | Check availability of replacement sizes, technical selection help, installation guidance, and support with failure analysis. | ISO 281 addresses dynamic load ratings and rating life; ISO 492 covers boundary dimensions and tolerances for radial rolling bearings. |
| Gears and gearboxes | Gear ratio, torque, speed, service factor, mounting arrangement, backlash, efficiency, lubrication, and noise requirements. | Verify rated output torque and allowable loads for the duty cycle; request drawings, maintenance instructions, and compatibility details for connected equipment. | Include gearing, lubricant, installation, alignment, energy consumption, and the cost of planned service or replacement. | Confirm access to seals, bearings, gears, lubricant recommendations, repair services, and technical documentation. | ISO 1328-1 specifies flank tolerance classification for cylindrical gears. |
| Belts and pulleys | Belt profile and length, pulley dimensions, center distance, transmitted power, speed, tension, and exposure to oil, heat, or dust. | Ask for the correct profile and matching pulley information; check installation and tensioning guidance and whether replacement belts are readily available. | Compare belt price with expected replacement interval, tension checks, downtime, and the consequences of a belt failure. | Check availability of matching belts and pulleys, troubleshooting support, and guidance on inspection and tensioning. | Use the applicable belt-series specifications and manufacturer data for the selected drive; requirements differ by belt type. |
| Fasteners | Thread size and pitch, length, material, property class, coating, corrosion exposure, and required tightening method. | Request product identification and material or property-class documentation; confirm thread compatibility and suitability of the coating for the environment. | Consider unit cost alongside corrosion protection, installation time, inspection needs, and the risk of loosening or replacement. | Confirm consistent identification, repeatable supply, and access to the specifications needed for future maintenance orders. | ISO 898-1 specifies mechanical properties for carbon steel and alloy steel bolts, screws, and studs. |
| Electric motors | Rated power, voltage, frequency, speed, torque, duty, efficiency, mounting, insulation, and enclosure protection. | Check the nameplate data against the application and power supply; verify starting requirements, mounting dimensions, and suitability for the installation environment. | Compare purchase and installation costs with energy use, controls, maintenance, and the cost of replacement or production downtime. | Ask about spare parts, repair options, wiring documents, service support, and availability of compatible replacement motors. | IEC 60034 is the IEC series covering rotating electrical machines; IEC 60529 classifies degrees of enclosure protection (IP Code). |
| Seals and O-rings | Inside and outside dimensions, cross-section, material, fluid compatibility, pressure, temperature, motion type, and surface finish. | Provide the fluid, temperature range, pressure, and movement details; request confirmation of material compatibility and installation guidance. | Assess the cost of the seal together with leakage risk, inspection frequency, replacement labor, and potential equipment contamination. | Check material and size identification, access to replacement seals, and help selecting alternatives if the operating fluid changes. | Selection depends on the application and material compatibility; confirm the supplier's stated limits for the specific seal compound. |