| Predominantly radial load | Deep-groove ball bearing or cylindrical roller bearing | Deep-groove balls suit moderate radial loads and can accommodate limited axial load. Cylindrical rollers are often considered when radial load capacity and stiffness are priorities. | Check radial load, speed, shaft deflection, lubrication, and whether the design must locate the shaft axially. |
| Combined radial and axial load | Angular-contact ball bearing or tapered roller bearing | Angular-contact geometry carries combined loads; contact angles commonly used in bearing designs include 15°, 25°, 30°, and 40°. Tapered rollers are suited to substantial combined loads and are commonly arranged in pairs. | Specify load direction, contact angle, bearing arrangement, preload or endplay, and thermal operating conditions. |
| Primarily axial load | Thrust ball or thrust roller geometry | Select thrust geometry when axial load is dominant. Thrust bearings generally are not intended to carry significant radial load unless the specific design supports it. | Check axial load direction, speed, alignment, and whether radial guidance must be provided by another component. |
| High radial load in limited space | Needle roller bearing | Needle rollers provide high radial load capacity for their small cross-section. A shaft or housing may serve as a raceway if its surface and hardness meet design requirements. | Check raceway hardness, surface finish, edge support, lubrication access, and the available radial envelope. |
| Angular misalignment or shaft deflection | Spherical roller bearing or self-aligning ball geometry | Spherical geometry can accommodate a degree of misalignment, subject to bearing type and design limits. It does not eliminate the need to control shaft deflection and housing alignment. | Determine expected misalignment under load and confirm internal clearance, seals, and mounting arrangement are compatible. |
| Corrosive environment | Corrosion-resistant steel, ceramic rolling elements, or a compatible polymer bearing component | Martensitic stainless bearing steels can offer improved corrosion resistance over standard bearing steel, but are not immune to corrosion. Silicon nitride rolling elements may be considered for specific hybrid designs. Polymer choices depend on load, temperature, and chemical exposure. | Check the specific chemical, moisture, cleaning agents, temperature, load, and lubrication. Confirm material compatibility rather than relying on a material label alone. |
| High speed or electrical insulation needs | Hybrid bearing with ceramic rolling elements, where suitable | Hybrid designs using silicon nitride rolling elements may reduce rolling-element mass and can provide electrical insulation through the rolling contacts. Suitability depends on the complete bearing and application. | Verify speed limits, cage design, lubrication method, electrical path, temperature, and any requirements for current discharge protection. |
| Dimensional accuracy and running performance | Specify a tolerance class applicable to the bearing type and dimensions | ISO 492 defines dimensional and running accuracy tolerances for applicable radial rolling bearings. P0 is a common normal class; tighter classes such as P6 or P5 may be considered when the application requires greater accuracy. | State which dimensions and runout characteristics matter. Confirm that the selected standard and tolerance class apply to the custom bearing design. |
| Operating clearance and fits | Specify internal clearance based on fits and operating conditions | Normal clearance, often designated CN, is a common starting point. C3 denotes clearance greater than normal; other clearance groups are available. Interference fits and temperature differences can reduce operating clearance. | Calculate the mounted and operating clearance, considering shaft and housing fits, temperature gradients, load, and any preload requirement. |
| Custom dimensions or unusual envelope | Define bore, outside diameter, width, shoulder geometry, and interface features on a controlled drawing | Non-standard dimensions should be tied to functional requirements rather than copied from a standard bearing without checking load capacity and support conditions. | Include datum references, fits, chamfers, fillets, surface finish, sealing features, and inspection requirements on the drawing. |