| Dual-Momentary, Center-Off Rocker | Momentary ON–OFF–ON | Common arrangement for separate IN and OUT commands | Press and hold one side to run the winch in that direction; release the rocker to stop the command. | Check that the switch returns to the center-off position and is compatible with the winch control circuit. |
| Momentary Single-Direction Rocker | Momentary ON–OFF | Single-direction operation, such as a dedicated IN or OUT command | The circuit is energized only while the rocker is held in the ON position. | A separate control is generally needed for the opposite direction. Confirm the required contact arrangement. |
| Momentary DPDT Polarity-Reversing Rocker | Momentary, center-off; double-pole, double-throw contacts | Reversing the polarity supplied to a compatible two-wire DC motor | Its contacts can swap motor polarity for forward and reverse operation while the rocker is held. | Use only where the winch circuit is designed for direct polarity reversal. Verify the wiring diagram and electrical ratings. |
| Momentary Control-Circuit Rocker | Momentary contact signal | Sending IN or OUT commands to a relay or solenoid control system | The rocker provides a low-current command; relays or solenoids handle the motor power switching. | Confirm the switch contact rating and control-system requirements. Do not assume the rocker can carry motor current. |
| Illuminated Momentary Rocker | Momentary ON–OFF or ON–OFF–ON, with indicator lighting | Hold-to-run control with a visible switch indicator | The illumination may indicate power, an active command, or another circuit state, depending on wiring. | Check the indicator’s voltage and wiring separately; illumination does not by itself confirm that the winch is operating. |
| Sealed Momentary Rocker | Momentary action with a sealed or protected actuator design | Winch controls exposed to dust, splash, or outdoor conditions | Provides the same hold-to-run action as its underlying contact configuration, with added environmental protection when properly rated. | Look for a stated ingress-protection rating and suitable installation conditions; sealing levels vary by product. |
| Latching ON/OFF Rocker | Maintained ON–OFF | Usually a power or enable function rather than a preferred directional hold-to-run command | The switch stays in its selected position after release, so the circuit can remain energized. | Use only when the control design calls for maintained operation and includes suitable safeguards; it is not equivalent to a momentary control. |