During the long-term use of a stone cutting machine, the cutting disc may need to be replaced due to wear. In order to ensure the continuous and efficient operation of the cutting machine, it is very important to master the correct method of replacing the cutting disc. Next, we will introduce you in detail the replacement steps and precautions for the cutting disc of a stone cutting machine.
We need to prepare a wrench designed for the cutting machine, align the raised part of the wrench with the hole on the cutting machine, and rotate the wrench to loosen the hole. Then press and hold the button on the back of the cutting machine, while loosening and removing the old cutting disc, and replacing it with a new one. Finally, we press and hold the button on the back of the cutting machine again, tighten the cutting disc holder, and firmly install the new cutting disc on the cutting machine. In the process of tightening the cutting disc or holder, we must keep pressing the button on the back to ensure that the cutting disc is tightened.
In the process of cutting stone, we need to pay attention to several places to ensure smooth operation. First of all, we have to choose the appropriate cutting tool, because different stones may have different cutting methods. At the same time, we must ensure that the surface of the stone is dry and free of debris before operation, so as to reduce resistance during cutting and improve efficiency. We must also pay attention to the sharpness of the cutting tools, because sharp tools can improve the accuracy and efficiency of cutting. We must always pay attention to safety during the cutting process and avoid injury.
(1) Before cutting the stone, we must measure the size. If paving marble on the ground, we should first measure the size of the ground to determine the size of the marble, then draw it on the marble with chalk, and finally use the cutter to cut it.
(2) Before preparing to use the cutter to cut the stone, we should choose the appropriate cutting blade. For stone cutting, it is best to use a diamond cutting blade. We should also check whether the cutting blade has any missing corners, whether the screws of the cutter are loose, and whether the wires of the cutter are damaged, etc., to ensure the safety of our entire cutting process.
(3) When using the cutter, we should cut the back of the stone, because the surface of the stone is relatively smooth. If we cut on it, it may slip and may also cause cutting errors. Therefore, we choose the less smooth back side as the cutting surface. We can also sprinkle some water on it before cutting to lower the cutting temperature of the cutting machine and make the whole process safer.
